AC & Air Duct Mold Removal in Cleveland, TX

Warning signs

• Dark or fuzzy spots on supply registers and the ceiling around them
• A musty smell that arrives with the airflow
• A drain outlet outside that has stopped dripping on hot days
• Water, rust or slime in the pan under the indoor coil
• Duct insulation in the attic or under the floor that feels damp
• Humidity indoors that stays high even with the AC running

Local conditions in Cleveland

Cleveland is a Liberty County city about 45 miles from Houston, bordered on the north by Sam Houston National Forest and crossed by I-69 and two rail lines. The Trinity River floods along its lowlands: in one spring flood, fast water washed out part of the road at New River Lake Estates and covered a bridge at The Preserve of Texas, and residents relied on boats and a tractor to get around. During Harvey, more than 7,000 homes across Liberty County were affected and about 800 had major damage or were destroyed. Any air handler or ductwork that sat in water belongs on the assessor's list. For homes that stayed dry, mold usually comes from long cooling seasons, clogged condensate lines and ducts that sweat in hot attics or crawl spaces under raised floors.

What affects cost

National ranges (HomeGuide, 2026) put mold work on an HVAC system or ducts at $2,000 to $10,000, and Angi's Houston cost data reports general mold removal averaging $2,016. Flood-soaked equipment that must be replaced, long attic or underfloor duct runs, tight access and coil or pan repairs push the figure up. In Texas, the consultant who writes the protocol and checks clearance is paid separately from the company doing the removal.

What happens when you call

You're connected with an independent local company and asked what you've seen. A mold assessment consultant inspects and writes a protocol, a separate company that holds a TDLR mold remediation license does the work, and the consultant confirms clearance. Replacement ducts or equipment go through the City of Cleveland's Community Development Permits & Inspections Division at 907 E. Houston St. Renters with unrepaired leaks or substandard conditions can file through the city's Code Compliance and Enforcement GovWell portal.