Mold Removal & Remediation in Crosby, TX

Can I handle it, or does my Crosby home need a professional?

Size and cause decide it. EPA says a homeowner can usually take care of a patch under about 10 square feet, and Texas lets you clean mold in your own house without a license regardless of size. Once growth covers a wall section, sits inside a cavity or follows a flood, a professional job makes sense. Crosby is a small unincorporated community in east Harris County, about 25 miles from downtown Houston, and storms here can dump a lot of rain fast. In an October 2015 storm the Harris County Flood Control District measured about 13 inches, and businesses at a Crosby shopping center had more than four inches of water on their floors. Water like that inside a house calls for cutting out wet drywall, not wiping it down.

Who writes the plan and who does the work?

A mold assessment consultant who holds a TDLR license inspects the house and writes a protocol covering the areas involved, the quantities of material, protective gear, containment and clearance criteria. A remediation company, which by Texas law cannot be the same company on that project, writes a work plan that follows the protocol and does the removal. Afterward the consultant returns for a post-remediation assessment. If the area passes, you get a clearance report, and within 10 days the remediator hands over before-and-after photos and a Certificate of Mold Damage Remediation.

What will it cost in Crosby?

Angi's Houston cost data shows typical removal from $863 to $3,329. A single bathroom or closet tends to land near the low end, while a flood job through several rooms runs higher. Ask both companies for written prices so you can see the assessor's fee and the remediation fee side by side, and ask the remediator whether drying equipment and debris hauling are included.

A note on rebuilding in Crosby

Because Crosby is unincorporated, the Harris County Office of the County Engineer handles permits. Replacing walls or repairing structure after a flood counts as development there, and work in the 100-year floodplain requires drawings sealed by a Texas architect or engineer. Call the county's Residential Group before starting, and check FEMA flood maps for your address if you are unsure of the zone.